Flushed tank water heater, replaced expansion tank.

This option if for us to cut plywood under tub in master bath to locate leak . Price to fix the leak will be a separate estimate Found Leaks at tub spout, over flow and around the drain. this was discovered by filling up the tub hlaf way pas the center of the overflow, waiting until it dorained past the overflow, and then letting all 50 gallons of water out of the tub through the drain. The customer would like install guarentees and is happy to have us furnish the parts for installation.Tankless information: Model: NPE 180-A2 Serial: 2077c21z0976313 Local regulator 3'x3/4" gas whip after regulator.Scope: -Secure wter to home and drain plumbing system. -Remove existing Roman tub filler. -Install new Roman tub filler with chrome finish. (preferably Delta) -Remove existing PVC Tub waste and overflow assembly and trap. -Install new waste, overflow and trap onto existing garden tub. (chrome trim) -Fill tub all the way and check for leaks and proper functionality on all nwly installed pa

This option is just for the replacement of the presure reducing valve-shut off water to home and drain system down -Cut out old prv -install new prv and shut off -set pressure to a safe pressure -test for leaks and functionality 1 year warenty

This price is to replace the leaking pressure reducing valve.

1. Water pressure in the home is above 80psi. This is considered high water pressure by code. High water pressure negatively impacts the entire p.umbing system. This is especially true for plumbing fixtures and appliances connected to the plumbing system.2. There are 16 push pull stops in the home. These are builder grade products that are know to fail when needed most which is in the case of an emergency. The supply line that is attached to these valid is factory cramped on and cannot be replaced.3. The 3 shower valves in the home are tough to turn and one of them is not consistent in its turn. This indicates the need for the valve to rebuilt.- In order to address the issues listed above, we will:1. Replace pressure reducing valve and set the water pressure to 70 psi.2. Replace all 16 push pull stops with proper emergency shut offs. We will also replace all supply lines to each fixture.3. Rebuild the three pfister shower valves.1 year warranty on workmanship

1. Existing water heater is a 3 year 50 gallon old gas unit. Customer states the water heater does not provide enough hot water for two people to shower.a. Unit appears to be functioning as normal. This could be caused by sediment build up that has settled above the burner assembly at the base of the tank.Service fee

1. Homes water pressure is above 120psi. This is considered very high water pressure by IPC code standards. High water pressure puts a strain on the entire plumbing system. Especially, plumbing fixtures and appliances connected to the system.2. The water heaters expansion tank has failed. Likely due to high water pressure. The expansion tank, further protects the system from high water pressure created by thermal expansion during the times that the water heater is heating water.3. Toilet in upstairs hall bath appears to be clogged. No sign of leaking at base or into ceiling below.4. Kitchen faucet is leaking. Likely due to high water pressure.5. Upstairs lavatory faucet in master bath, is leaking. Likely due to high water pressure.6. Upstairs master bathtub is slow draining. Customer has used Drano.- In order to address the issues listed above, we will:1. Replace the homes failed pressure reducing valve. We will set the homes water pressure to 70psi.2. Replace the wat

Cut out old flange from crawlspace. Install a new flange and mount to floor

This estimate is to:Service fee + diagnostic to source point of leakThere is a leak on the cold water line in the attic at a 3/4” 90 elbow CPVC fitting. This fitting has a hairline crack in the 90 fitting itself. This is causing water damage to the walls and ceiling. In order to make sure this is the only leak in the area we will need to Cut open drywall at water spots in the ceiling to ensure that is the only source of leak.Once we have located all points of failure on the pipe, we can give options for a solution. Waterlines in attic/wall spot repairThere is a leak on the cold water line in the attic at a 3/4” 90 elbow CPVC fitting. This fitting has a hairline crack in the 90 fitting itself. This is causing water damage to the walls and ceiling. In order to make sure this is the only leak in the area we will need to Cut open drywall at water spots in the ceiling to ensure that is the only source of leakAfter opening up the wall, we were only able to see the leak coming

1. Existing water heater is over 22 year old. The average service life of a gas tank style water heater is 8-10 years.a. The unit has no records of service.b. Unit has no expansion tank as it pre dates the code requiring one.c. The unit is located in an attic storage room. Should it leak, it could cause significan damage to the home.- In order to address the issue listed above, we will:1. Install a new Bradford White 50 gallon water heater.a. Bradford White is widely considered the best tank style water heater manufacturer on the market today.b. We will reinstall the existing recirculation pump onto our new unit. There is no warranty on the pump system or it's components.c. We will install a water heater stand and new water heater pan.6 year manufacturer warranty from Bradford White 1 year workmanship warranty

1. The dual unit tankless system is over 9 years old. We expect these units to have a service life of 20-25 years if properly service bi-annually.a. When turning on multiple fixtures, the secondary unit never fired on. This works the master unit harder than normal, as it alone, cannot keep up the flow to temperature ratio that the unit operates works off of.b. They have no records of previous service. These units need to be service every two years at a minimum.c. Secondary unit had an error code 439 (Flow sensor error) a part will likely need to replaced after trouble shooting with tech support.- In an attempt to address this issue, we will:1. Properly service and flush both of the existing units.a. If the secondary unit still does not function after this we will have to further diagnose the unit through Navien tech support and will likely have to replace one or multiple parts on the unit. There we be an additional charge for each of the tasks. The cost to begin the diagno

This option is to replace the leaking faucet in the hall bath with a new customer supplied faucet, and flush tankless heaterSteps for this quote-shut off water to leaking faucet -remove existing faucet and supply lines -install new customer supplied faucet -turn on water and bled out air -test for leaks and functionality -run dedicated calcium solution through water heater to clear build up *disclaimer* we do not warrenty customer supplied parts This price is to install the customer supplied, outside shower valve. We will first remove the old valve before installing the new one.No warranty or guarantee on customer supplied parts or fixtures.No warranty against freezing as we are installing the valve on the exterior of the home per the customers request.

provided estimates for repair of replacment of main water line

Install new shower cartridge Install shower trim and caulk trim to shower walltechs removed and installed a new moen cartridge in the upstairs hall bathroom. Techs turned on water to the house inspecting for leaks. No leaks found. Techs re-installed customers shower trim and caulked around the shower trim. Techs adjusted the water pressure on the prv from 90 psi down to 60 psi so that there is no excessive water pressure inside the home. Pressure above 80 psi can put strain on the plumbing system causing leaks. Techs turned off the hose bibs and drained the hose bibs to winterize.Disclaimer - if the pressure is above 80 psi inside the home, we will need to install a new pev to warranty the cartridge replacement

Secure water to tankless heater and turn off. Mix descaling solution and assemble servicing pump station. Run descaling syscle. Clear filtures. Flush heater with clean water. Remove air from lines. Return heater to service.Return to install sediment trap cap on Navien and install customer supplied washing maching hoses at no additional cost and no guarentee.

Kitchen: Kitchen faucet spray hose webbing frayed. Consider rebuilding emergncystops.Downstairs half bath: Consider rebuilding emergency stops.Primary Bath: Tub sprayer needs new hose. Water spotted around water pick next to right hand sink. Consider rebuilding emergency stops.Laundry: No issuesUpstairs guest Bath: Replace push/pull stops under vanity. Consider rebuilding emergency stops. Rebuild or replace toilet within next year.Upstairs back bath: Rebuild or replace toilet within next year. Tub spout diverter not working. Need to replace chrome Tub spout. Consider rebuilding emergency stops.Upstairs center full bath: Toilet will need a new flapper within next year. Replace push/pull stops under vanity. Consider rebuilding emergency stops.Water heater: Installed Aug 2019 Last serviced May 2024 Navien 240-A npe Dedicated recirculation. Located in garage.Home facts: Build 2007. City water. Ceptic tank. Home plumbed in copper with a little pex. Pvc drains.

PI

tech inspected water heater. customer stated that the t&p valve was draining out and there was water sitting in the pan. Tech tested water pressure at water heater and hose bib and water pressure was 120 psi. High water pressure was the reason why the heater was leaking. tech gave options for a new heater and prv.

Safety check

Safety check

This option is just to replace the prv to get your home to a safe pressure-Shut off water to home and drain system -Cut out existing prv and stops -glue new pex x cpvc adapters -put in new prv and stop -set a safe pressure to home -Turn water back in and bled out air -test for functionality

Safety check

Safety check

-

Technicians will drain clean amin line through clean out located approximately 5' from supposed blockage. After clearing blockage, technicians will then ca era line to inspection issue that is causing backup. No warranty on drain cleaning